how to setup a reverse osmosis system How to Convert a Fixed Gear Bike to Variable Speed-Ocpuritech

how to setup a reverse osmosis system How to Convert a Fixed Gear Bike to Variable Speed

by:Ocpuritech     2019-08-17
how to setup a reverse osmosis system How to Convert a Fixed Gear Bike to Variable Speed
Riding a fixed-Cycling on different types of terrain requires more than the physical strength that many cyclists do not have.Change your bike to variable speed and you can manipulate the same different terrain with less effort.Variable speedThe gear drive system helps you improve your efficiency by changing the pedal speed.Change your rear single gear to multi gearSpeed box and add Pad pod will convert your bike to variable-speed cycle.Teaching difficulty: fix the bike on the bike stand, or reverse the balance on the handlebar and seat.Take off the chain and put it aside.Get all the air out of your rear tire.If you are using a medium pull or v-brakes.Remove the rear wheel by releasing the quick wheelrelease lever.A bicycle without a quick release needs a wrench to loosen the nuts on both sides of the axle.After removing-wheel fixed-Slow down the gear by loosening the lock-Ring outside the gear set.Slide the fixed gear down the hub.New variable-Set the speed gear with the flower keyway on The Hub.Push the gear set to the wall of the hub.Apply a thin layer of grease on the locked threadring.Tighten the lock-Ring that holds the gear in place.Please note that a bike with roller coaster brakes will require a new hub or wheeland-Hub combination.Put the wheels back in the chain and tighten fast-Release or shaft nut.Inflate the tire and connect the center to pull or v-If you have brakes on your bike.Remove the handle from the right side of the car.Slide the pad pod to the pole with cable on the left.Put your hand back in your bar.Route the transmission cable down the frame of the bike to the left side of the rear shaft.Connect the rear transmission to the frame or hanger using an Allen wrench.Pass the pad cable through the cable slot on the rear transmission and gently tighten the bolts on the cable.Put the chain back on the bike.Transfer the pod to the center position and place the chain in the middle rear gear.Loosen the bolts that fix the transmission cable and use pliers to loosen or tighten the transmission cable when aligning the transmission and intermediate gears.Remove the bike from the stand.Turn the bike back to the wheel.Before riding for the first time, sit gently on the bike and check for sports and parts.The tip and warning article by Jeremy SlaughterJeremy Jeremy is a tax, accounting and small business expert.After completing the master's degree in accounting from Keller Graduate School of Management, slaugtver co-An accounting and tax company has been set up, where writing is a daily job.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标