How do small and medium stainless steel pure water treatment equipment need to be cleaned regularly

How do small and medium stainless steel pure water treatment equipment need to be cleaned regularly?

by:Ocpuritech     2021-06-25
How do small and medium stainless steel pure water treatment equipment need to be cleaned regularly? Author: small and medium sized stainless steel water treatment equipment is a water purification effect of ultraviolet disinfection equipment itself with the system allows the water a longer shelf life, and a lot of deep rich solution of oxygen. However, the pure water production equipment also needs to be cleaned regularly, otherwise it will cause source pollution, so that the pure water produced will be substandard, and it will also affect the normal use of the equipment. So how should we regularly clean the small and medium-sized stainless steel pure water treatment equipment? Let's take a look at the specific cleaning operation methods: 1. Use low-pressure flushing technology for flushing: we also need to regularly use the equipment daily Flush our equipment. Since long-term use will cause equipment pollution and cause equipment to fail to operate normally, we should occasionally use low-pressure flushing technology to clean the dirt on the surface of the equipment regularly. 2. Equipment stoppage operation: Protection will often show some fluctuations when we use the equipment, so we should stop the operation appropriately, and we must take certain protective measures when we stop the operation for a short time, once it is unreasonably handled If so, it is quite possible to cause the performance of water treatment accessories and consumables to decrease or directly not be used. Short-term shutdown is compared to the system used for another 14 days. We can use low pressure below 3 days to flush to protect the equipment. After our repeated practice, we recommend that the majority of users use less than 2d low pressure for flushing when the water temperature is higher than 19 degrees, and when the water temperature is below 19 degrees, we can use 3d low pressure for flushing. , We must close all valves after each flush. 3. Use chemical methods to clean the membrane of the equipment: Under normal operation of our equipment, the membrane of the equipment is easily covered by some microorganisms or other inorganic substances on its surface, which directly affects its ability to operate. Therefore, in order to better use the equipment, we need to use chemical methods to clean the membrane of the equipment. Generally, our normal cleaning time is best to clean once every six months. Once our system has to be cleaned once a month, it means that we need to improve the pretreatment system and adjust its parameters.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标