How to perform pressure test on small and medium-sized industrial wastewater reuse equipment-Ocpurit

How to perform pressure test on small and medium-sized industrial wastewater reuse equipment?

by:Ocpuritech     2021-05-07
How to perform pressure test on small and medium-sized industrial wastewater reuse equipment? Author: small and medium industrial wastewater reuse after installation, the need for equipment stress testing equipment. The purpose is to check the equipment for leakage, pressure drop, and equipment damage, and also to ensure that the small and medium-sized industrial wastewater reuse equipment will not be too high or too low to cause the equipment to fail to operate during use. In order to allow users to correctly grasp the pressure test method of small and medium-sized industrial wastewater reuse equipment, I will briefly introduce you today. 1. After installation of small and medium-sized industrial wastewater reuse equipment, the strength test pressure and tightness test pressure (ie design pressure) of all equipment shall be carried out according to the pressure indicated on the equipment nameplate. The test medium is clean water, and the test time is 30 minutes. It is qualified to check that the equipment has no leakage, no pressure drop, no damage to the equipment, and no deformation by visual inspection. 2. The pressure test system must be equipped with two pressure gauges (that is, one at the highest point and one at the lowest point), and the reading of the pressure gauge at the highest point shall prevail. The range of the pressure gauge is 1.5-2 times of the highest pressure of the test system, and the accuracy is 1.5. 3. After the pressure test of the small and medium-sized industrial sewage recycling equipment is completed, the water should be drained in time, and the equipment should be dried and sealed with compressed air. Through the introduction of the above article, how much do you know about the pressure test methods of small and medium-sized industrial wastewater reuse equipment? Pressure testing of the equipment is the key to testing the quality of small and medium-sized industrial wastewater reuse equipment. After installing with the equipment, be sure to perform a pressure test. This is the end of the introduction to the pressure test of small and medium-sized industrial sewage reuse equipment. If you want to know more information about sewage treatment equipment.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标