How to solve the problem of failure of small and medium-sized industrial water purification equipmen

How to solve the problem of failure of small and medium-sized industrial water purification equipment?

by:Ocpuritech     2021-04-06
How to solve the problem of failure of small and medium-sized industrial water purification equipment? Author: After we buy small and medium industrial water treatment equipment is not once and for all, the daily also need proper maintenance and maintenance measures. If the equipment is not cleaned and maintained regularly, small and medium-sized industrial water purification equipment sometimes has the following failures, which affects work efficiency. The following is a brief introduction to how to solve the failure of small and medium-sized industrial water purification equipment. 1. After the water is full, the machine repeatedly jumps off. If this failure occurs in the small and medium-sized industrial water purification equipment, then there must be a pressure leakage phenomenon in the system. The first may be that the raw water pressure is not enough, and the second may be that the check valve has appeared. Pressure relief failure, the third possibility is the failure of the high-voltage switch, these failures will cause the machine to repeatedly take off after the water is full. 2. Pure water does not flow out when the pressure tank is full. At this time, check whether the pressure tank ball valve is damaged or the pressure tank has a pressure leakage failure. At the same time, if the rear activated carbon is blocked, it will also cause this failure. 3. Severe proportional imbalance between wastewater and pure water. In this case, first check whether the flushing solenoid valve is faulty and whether it has been damaged. The second is to check the waste water proportioner. Too much conduction or blockage will cause malfunctions. Finally, it is ruled out whether the reverse osmosis membrane is blocked and its filtration rate is seriously reduced. 4. The host is repeatedly flushed. This failure is caused by the loosening of the flushing switch and the failure of the waste water ratio. Basically, there are only these two possibilities. Pure water equipment factories often need to use extremely pure ultrapure water in the production of electronics, semiconductors, liquid crystal displays, and photovoltaics. If the pure water quality does not meet the requirements of the production process water or the water quality is unstable, the subsequent processes will be affected The treatment effect and service life. In the production of electron tubes in the photovoltaic industry, if impurities are mixed into them, it will affect the emission of electrons, and then affect the amplification performance and life of the electron tubes. In the production of kinescopes and cathode ray tubes, the inner wall of the phosphor screen is coated with a layer of fluorescence by spraying or precipitation Substances, if the copper content in the prepared pure water is above 8ppb, it will cause luminescence discoloration, and the iron content above 50ppb will cause the luminescence to change color, darken, flash, and cause bubbles, streaks, light leakage points and other waste products.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标