Introduction to the debugging steps of EDL industrial ultrapure water treatment equipment before use

Introduction to the debugging steps of EDL industrial ultrapure water treatment equipment before use

by:Ocpuritech     2021-07-10
EDL industrial ultrapure water treatment equipment before using the commissioning steps describe the article: the quality of the environment pollution water quality down a lot, and now the city there is a pungent taste of tap water, add a lot of bleach and chlorine, In addition, as in the transportation process The water pipes have not been repaired for a long time, resulting in aging of the water pipes, secondary pollution and unreliable water quality. This has also led to the rise of pure water. Previously, the equipment on the market was uneven. Therefore, it is necessary to choose a high-quality EDL industrial ultra-pure water equipment. Before the EDL industrial ultrapure water equipment is officially put into use, it is necessary to debug the EDL industrial ultrapure water equipment. After the debugging is completed, the purified water equipment can be used to prepare purified water after the problem is solved. The steps of the equipment mainly include the following contents: 1. Detect and analyze whether the influent water of the purified water equipment meets the requirements before the water-passing debugging of the equipment can be carried out.  2. Automatic water quality monitoring system that adjusts the pressure control of the water supply pump.  3. Check whether the pipeline connection in the purified water equipment is perfect, and at the same time adjust the water supply volume to be greater than the water inlet volume of the purified water equipment.  4. Open the discharge and return valves of the purified water equipment, and start the pretreatment device, and at the same time adjust the water supply volume to be greater than the water inlet volume of the purified water equipment.  5. Turn on a pressure gauge switch, total water valve, each inlet valve, concentrated water outlet valve and fresh water discharge valve. 6. Close the discharge valve of the water pump, and close the main water inlet valve of the purified water equipment after the components are full.  7. When the inlet pressure of the water pump is greater than 0.2MPa, flush for 15 minutes and check the high and low pressure pipelines at the same time.   8. Adjust the inlet valve and concentrated water outlet valve of the purified water equipment so that the pressure of the inlet water reaches 0.15~1.5MPa, and the concentrated water discharge volume is the water production volume.  9. Detect the conductivity of purified water. If the conductivity meets the requirements, open the outlet valve and close the drain valve. The above is the relevant content introduced by the environmental protection company, I hope it will be helpful to you. If you still have any questions you don’t understand, you can call us and answer them for you.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标