Technology Sharing|How to replace the filter element of the ultrapure water machine in the small and

Technology Sharing|How to replace the filter element of the ultrapure water machine in the small and medium laboratory?

by:Ocpuritech     2021-04-02
Technology Sharing|How to replace the filter element of the ultrapure water machine in the small and medium laboratory? Author: sized laboratory ultrapure water machine is fully automatic control system can be set to run automatically backwash, regeneration procedures; reverse osmosis and reverse osmosis provided with a return line, small laboratory ultrapure water The machine is equipped with a chemical cleaning device and a disinfecting device. After a period of use, the filter element of the ultrapure water machine in the small and medium-sized laboratory will gradually decrease in performance as the accumulation of dirt is trapped. It must be replaced regularly. Those who use the ultrapure water machine in the small and medium-sized laboratory will Know that if you want to ensure the stability of the ultrapure water machine in small and medium-sized laboratories, you must master the method of replacing the filter element and correctly disassemble and install it. Now I will give you a detailed introduction to the correct replacement steps of the ultrapure water machine filter element: 1. The replacement of the filter element must be performed under the condition of cutting off the water source and power source. Water will usually flow out during the replacement process. Please prepare a basin, towels and other cleaning tools to clean the machine after replacing the filter element. 2. The 'O'-shaped sealing ring cannot be damaged or lost, otherwise it will cause water leakage. At the same time, try to avoid displacing or deforming the 'O' seal ring when tightening the filter housing. The steps of replacing the front three pretreatment filter element are: (1) Turn off the water inlet valve switch. (2) Open the reverse osmosis faucet to drain the residual water in the pipeline. (3) After the water no longer flows out, use the filter housing wrench to open the filter housing with the filter element. (4) Remove the old filter element and put in a new filter element of the same specification. (5) Coat the black 'O' seal ring above the filter housing with other lubricants, and then put it into the groove in the filter housing. (6) Tighten the filter housing in a vertical manner to avoid displacement or deformation of the 'O' seal ring. (7) Check again whether there is water leakage at each interface of the pure water machine. I believe that after understanding the above steps, you already have the answer to how to replace the filter element of the ultrapure water machine in the small and medium-sized laboratory. Warm suggestion: users should learn more about the water inlet requirements of the ultrapure water machine in the small and medium-sized laboratory, and pay attention to the ultrapure at any time If the water inlet condition of the water machine is abnormal, adjust it in time to ensure the process performance of the system and the quality of water produced. How to properly maintain the ultrapure water machine in small and medium-sized laboratories is also a prerequisite to ensure the normal operation of the ultrapure water machine. For more information, visit our website one by one!
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...
WhatsAPP图标